- What it runs on
- Machines and low-frequency EM
- What it decides
- Torque, loss and flux in the gap
- Cost of being wrong
- A motor map that the dyno does not match
What it checksCriterion
- 01Air gap resolutionelements across the gap
The one region where a coarse mesh changes the number, not the picture.
- 02Nonlinear material loopB–H iteration converged
Saturation solved to a tolerance, or stopped at an iteration count.
- 03Timestep against electrical periodsteps per electrical cycle
Time resolution set by the mechanical rate, not the electrical one.
These are criteria, not results. Nothing here has been measured — the product is not built.
What comes back
- The cause, and the line of solver output it came from
- The change, as a diff you can reverse
- Physics checks, measured against their limits
- A record somebody else can open on a link
Targets
- FEMM (target)
- Elmer (target)
- Commercial EM adapters (planned)
Named as intent. No adapter for any of these exists today.
Standing
Not built. Named here because simulation teams that run flow and thermal usually run this too, and because the same evidence record is what their reviewers ask for. There is no adapter today.